Make Sure That The Transducer Installation Is Right
Posted by Boating Laws - 01/09/10 at 10:09 amWhen Fitting and installing a depth-sounding or fish-finding transducer onto a boat requires familiarity with the transducer being attached too as the boat or the hull being attached to. Several factors have to be considered in advance when setting up a transducer in order not to waste time, effort, and money. You can find various types of transducer installation mount namely, Transom mount, shoot-thru-hull mount, Bolt –thru-hull mount and Trolling motor mount.
In acquiring a transducer, notify your source about the boat you’re going to use it with. This is incredibly critical since not all transducers will be a fit for your boat. Hence, it’s also essential that you get the viewpoint of a boat expert in the event you are not familiar with boats.
Make certain that your new products are compatible and operational. It can be usually suggested to test the transducer with your instrument or fishfinder before installing. Plug the transducer into the electronic display and hang the transducer overboard in at least 5’ of water (deeper is much better). Examine all available frequencies for operation. If equipped with speed, spin the paddlewheel and examine for a speed reading.
The exact mounting location can only be determined by examining the hull. See your sensor’s Installation Instructions and Owner’s Guide for hull-type recommendations. Check for clean water flow while making turns. Staying as close to center line as possible need to supply better results. Make certain the transducer is not going to come out of the water while making turns.
If the hull is stepped, the transducer should be mounted forward of the initial step. This signifies that only in-hull or thru-hull transducers are appropriate for installation on this kind of hull. Make certain the deadrise angle of your hull doesn’t exceed the maximum allowed by the sensor. Make certain there’s adequate space inside the vessel for any tank and transducer, transducer stem, or removing an insert.
It can be very good to keep in mind some protocols on what not to do during transducer installation: Mount the device where by it is not going to get turbulence, prevent mounting in places wherever transport support for the boat is secured. Do not install where by there are loose boat fittings. Prevent reverse angles of the hull which can hamper data. Just knowing these few items about transducer installation can already save you much.
To know more on transducer installation , please go to http://transducersite.com/transducerinstallation , so you can read about transducer installation
